Strand VISION.NET SENSORS
Strand VISION.NET SENSORS
VISION.NET Occupancy sensors provide energy saving lighting controls for your facility. Sensors easily integrate into any VISION.NET architectural control system, providing direct control of VISION.NET compatible dimmers and low voltage relay switching systems. The VISION.NET Photocell Daylighting Sensor is a low-voltage daylighting sensor that measures changes in ambient light and controls its connected lighting loads according to the user’s programming. The unit is able to decipher minor changes in light levels (such as passing cloud cover, intermittent shadowing, etc.) to prevent unwanted or inadvertent light cycling.
Preço Sob. Consulta
Photocell Daylight Sensor Features
Detects and identifies pre-programmed ambient daylight levels to turn on lights when needed, and to prevent them from turning on when the ambient daylight is above a certain level
Upon detection of a pre-programmed daylight set point, the sensor may be programmed to execute any Vision.net command across the architectural control network
User-friendly programming unit is available to configure the sensor without the use of ladders
· “Laser Painting,” a sensor with the laser pointer built into the remote, provides accurate sensor selection for programming
· Sensor can be programmed with a laptop PC as well as with a remote
· Status LEDs facilitate sensor programming
· Each sensor can be programmed to execute any Vision.net system command
Ceiling Occupancy Sensor Features
Wide coverage area available for areas up to 4000 square feet
High-bay version available for ceiling heights up to 24 feet
Sensor-masking kit included to provide coverage area control
Integrated photocell can be programmed to prevent light source activation if sufficient daylight is present
User-friendly programming unit is available to configure the sensor without the use of ladders
· “Laser Painting,” a sensor with the laser pointer built into the remote, provides accurate sensor selection for programming
· Up to eight sensors can be supported on a single data link
· Sensor can be programmed with a laptop PC as well as with a remote
· Status LEDs indicate occupancy detection and facilitate sensor programming
