BINDER TYPE: Water-based, vinyl acrylic

FINISH: Ultra-Flat

DILUTION: Ready for use directly out-of-can

FILM THICKNESS: 2 mils dry film

VOC Content: Max 50g/L  

SHELF LIFE: Minimum 12 months for an unopened can

SURFACE PREP:

Surfaces should be clean, dry and free from dirt and grease. Prepare surfaces using an appropriate primer. If painting a new plaster surface, prime wall with a primer/sealer designed for raw plaster. For best results use DigiComp® HD over a white primer, such as Rosco Tough Prime White. Make sure the prime coat is adequate and that it results in a flat and even surface. Any blotchy areas or roller marks may bleed through and cause an uneven finish coat.

APPLICATION:

Stir contents very well before and during use. Commercial shaking one day before use is recommended. Rosco DigiComp® HD paints come ready to use straight out of the can. Check your batch numbers. Different batches of paint may vary slightly in color. Combine different batch numbers together to maintain color consistency throughout your project. Using a 3/8” nap roller, apply in thin, even, uniform coats, with overlapping strokes - making sure to keep a wet edge. Change roller direction often to avoid patterns and streaking. An appropriate airless spray (HVLP recommended) system may also be used. Make sure to keep the nozzle of the sprayer equidistant from the surface during application. For full application instructions, please see our How To Paint Your Wall/Cyc with DigiComp® HD document, or watch the video.

COVERAGE:

Approx. 300 sq. ft./US gal. (27 sq. m/US gal) Due to the nature of the bright pigments used, two coats of DigiComp® HD are recommended for even coverage.

DRYING TIME:

30 minutes to one hour, depending on temperature and humidity. Allow first coat to dry completely before applying the second coat.

CLEAN UP:

Wash tools thoroughly with mild soap and water. Close containers tightly after use.